Read your electricity bill
Find the variable price per kilowatt-hour. If energy and delivery are listed separately, include the applicable variable charges.
Estimate the electricity cost to run your mini-split using your operating hours, billing period and local electricity rate.

Heat pump coefficient of performance (COP) changes with outdoor temperature:
Check your model's spec sheet for rated COP and capacity at low temperatures. Use those values, or a metered reading, in the calculator.
Illustrative operating times at your entered average power and rate.
For a full-year estimate, enter the days you expect each pattern to apply, the average electrical power while running, and the hours per day. Use zero hours for months when the system stays off.
Example schedules are editable. Each row uses days × hours × average kW × rate. The total covers variable electricity charges at the flat rate above. A day belongs to one row, even if you use both heating and cooling that day.
Record system-only kWh for a representative week. Divide by seven for average daily use. For example, 35 kWh in seven days is 5 kWh per day. At $0.20/kWh, 30 similar days cost $30. Repeat in a colder or warmer week before projecting a whole year. A whole-home bill also includes appliances and other loads.
Find the variable price per kilowatt-hour. If energy and delivery are listed separately, include the applicable variable charges.
Use measured energy over a known period or a measured average while running. A unit’s maximum rated draw can exceed its average.

0.7 kW × 8 hours × 30 days at $0.20/kWh
$33.60 per 30 days
0.9 kW × 8 hours × 30 days at $0.20/kWh
$43.20 per 30 days
1.4 kW × 8 hours × 30 days at $0.20/kWh
$67.20 per 30 daysThese examples use assumed power and hours. Room type alone cannot predict consumption.
Enter your own operating hours for a typical day and for a colder day. Values are illustrative until you replace them with your own readings or your unit's specification.
This compares electricity cost only. It does not model heat-pump efficiency at each temperature, equipment sizing, or whether the room reaches setpoint. Changing the rate or hours changes both scenarios.