Quick answer
Use cool mode when the room is too hot and you want it to reach a temperature you choose. Try dry mode when the temperature already feels comfortable but the air feels damp. Dry mode can still cool the room. Whether you can adjust the temperature or fan speed depends on the model.

What does dry mode actually do?
Moisture from room air condenses on the cold indoor coil and leaves through the drain. Cooling can remove moisture this way too. The difference you notice is how the unit controls the cycle. MRCOOL describes a dry setting that cycles the compressor without using your selected temperature as its target. Check the operating manual for the indoor model on your wall before assuming your remote works the same way.
A rainy-evening bedroom test
Suppose your bedroom feels sticky at 73°F. Lowering the cooling setpoint might leave you reaching for a blanket. To see whether dry mode suits this room, place a thermometer and humidity meter away from the supply air and record both readings. Keep doors and windows in their usual positions.
- Note the start time, temperature, relative humidity and how the room feels.
- Select dry mode following your manual. Check again during the session. End the trial if the room gets uncomfortably cool.
- Compare temperature and humidity together. A lower temperature alone does not tell you whether the room is more comfortable.
What if the room stays damp?
If the problem returns every rainy day, tell your installer when it happens, what rooms are affected and whether there is visible water intrusion. A room that is already cool may need moisture control independent of cooling. Interior water dripping from the head also deserves a service check. Collecting water inside the room is different from condensate leaving through the drain.
Does dry mode use less electricity?
The remote setting alone cannot answer that. Compare measured kWh during similar weather and occupancy, using the same duration for each trial. Multiply the difference by your electricity rate. For example, a measured difference of 1.5 kWh at $0.20/kWh is 30 cents for that trial. Use the running-cost calculator with your readings before projecting a monthly difference.
Manufacturer reference
MRCOOL’s dry-mode operating guidance describes its controls and the limits of using cooling equipment for persistent humidity.
